Corvette and Cobra
Driveshaft Specialist can build new custom driveshafts for Corvette's and Cobra's in Steel or Aluminum.
Corvette Products:
In addition to the new products listed we will also repair/refresh your existing driveshaft or axle shafts with Spicer XL U-Joints. We offer Hi-Speed Balancing of all components.
Transmission Yokes:
Corvette
27 Spline Transmission Yoke-Disconnect
OE length at 4.875 (4 7/8) overall length. 1310 series U-Joint.
Corvette 32 Spline Transmission Yoke-Disconnect
OE length at 4.960 (very close to 5") 1330 series U-Joint.
Corvette 27 Spline Snap Ring - Non Disconnect
OE length at 4.875. Used on C4 Corvette applications. Note: Does not have little damper ring. 1310 Series U-Joint.
Driveshafts and Axles are shown un-welded and un-painted. You will receive it Assembled, Hi-Speed Balanced and Painted.
Complete Driveshaft - 1310 Series, Spicer XL U-Joints, 27 Spline yoke. (Assembled - Balanced)
Complete Driveshaft - 1330 series, Spicer Xl U-Joints, 27 Spline Transmission Yoke. (Assembled - Balanced)
Complete Driveshaft - 1310 series, Spicer Xl U-joints, 27 Spline snap ring Transmission Yoke.
Corvette Axles shafts for C-3.
Corvette Axle shafts for C-4.
Aluminum Axle shafts w/ Spicer XL UJ. 3.0"
Corvette
Axle Flange
This is an OE exact flange from Spicer. $71.66
Note: The flanges tend to get a bit tweaked or warped when changing U-Joints. Be very careful and only use enough force to get the job done. If U-Joint feels rough or notchy when completed, the flange is damaged and will wear a U-Joint out much quicker.
Cobra Products:
Driveshaft Specialist carries all driveshaft components for OE Cobra or custom built Cobra's. We build custom driveshafts to your exact dimensions or we can modify your existing driveshaft to Cobra specs.
We
inventory all different types of transmission yokes.
If you are using later model 5 and 6 speeds we will have the correct yoke required. Typical Ford Transmission Yokes are listed below. Check the Transmission Yoke Page for more choices.
28
Spline 1310 Series Transmission Yoke. Spicer Product-
not some cheapo part
31 Spline 1310 Series Transmission Yoke. USA part.
Cobra's can use a variety of Transmissions and Differential components. It is hard to price for each and every combination. Please call with your set up.
1310 Driveshaft pricing without Transmission yoke or Flanges. Please call with your exact set up and we will get you exact pricing.
Aluminum Driveshafts in 3.0" x.125 and 3.5" (without Trans Yoke or Flange) Discount on very short shaft. Please Call
We
have all of the Differential Pinion Flanges for different set ups.
Ford 8.8 used a 3.5 Bolt Circle and a 4.25 Bolt Circle. This is measure diagonally from center to center on holes.
Jaguar Flange for the Dana 44 IRS 1310 UJ